The Stone Crusher should be carried out every two years a ma

The Stone Crusher designed with simple structure, easy maintenance, and easy operation, the body of primary Stone Crusher with two structural forms: one for the whole casting; the other is high quality steel welding, the eccentric shaft made of high-quality carbon structural steel, fitted with bearings at both ends and secured to the rack. When the Stone Crusher motor driven pulley and through the jaw of the eccentric shaft drive to and from the movement, the material crushed to achieve the purpose of the broken tooth plate. The Stone Crusher adjusting device is mainly used to adjust the size of the discharge opening. Usually the Stone Crusher is used to work together with spring cone crusher.

The Stone Crusher is mainly used for raw materials in the crushed and broken bits, such as coal, gangue, coke, limestone, pyrite, phosphate rock. The outputs then are transferred by Belt Conveyor. Its broken for the song moving extrusion, the maximum block of the broken material should be less than the selection of Stone Crusher machine model discharge port size 10-60 mm size-specific reference parameters. Primary Stone Crusher is widely used in metallurgical industry, mining industry, the laboratory industry, as well as coal, coke and other industries.

The primary Stone Crusher must be started under no-load. In order to ensure long-term use of the Stone Crusher machine, should always raise the calcium base grease on the activities of institutions and bearing support plate and the slider, the support plate and moving jaw fulcrum refueling once every 15 days, each bearing refueling every 30 days. Each class to start, to carefully check the Stone Crusher teeth plate is loose, the work should always check the Stone Crusher work of the tooth plate, compared with ring hammer crusher,Stone Crusher should be thoroughly troubleshoot irregularities, in order to prevent loosening or displacement of the tooth plate and squeeze bad Stone Crusher machine operation, is strictly prohibited any clean-up and installation and removal belts work to prevent accidents. The Stone Crusher should be carried out annually once disassemble maintenance. The Stone Crusher should be carried out every two years a major overhaul.

Thank you for your interest in YiFan. Please use any of the methods below to get in touch with us.
Add: The Middle of Zhengyuan Road, Xingyang Eastern Development Zone.
zip:450100
E-mail：yifanseo@yfmac.com
MSN On line: yifancrusher@yahoo.cn
ICQ: 639607958 QQ: 2502761202
Tel: +86-371-64628852 Fax: +86-371-64628872